Replacing the Lenses

X4 Air's lenses are fully replaceable with the Replacement Lens Kit, so you can easily swap out damaged lenses in a few simple steps.

1. Align the orange mark on the lens grip tool with the white mark on the lens ring.
2. Rotate the lens grip tool twice counterclockwise until the lens ring is loose, then lift the tool to remove the ring.
3. Use the removal tool to gently lift the edge of the old lens and remove it. Check that the inner lens is clean and free from debris.
4. Pinch the suction cup with your fingers to pick up the new lens from the lens case and install it.
5. Align the lens ring with the camera and rotate the lens grip tool twice clockwise to install. Remove the suction cup. The white mark on the front lens ring should align with the microphone. The white mark on the rear lens ring should align with the center of the wind guard.
6. After replacing the lens, use the in-camera Stitching Calibration feature in settings for the best stitching effect. Swipe down on the touchscreen, tap Settings, and scroll down.

The Replacement Lens Kit must be purchased separately.

Notes

• Place a lens cloth under the camera to avoid scratching the lens.
• If the rubber seal around the inner lens comes loose, place it back in its original position before continuing.
• Clean the inner lens carefully, as dust, dirt, or debris can affect image quality. If needed, use the included lens blower, brush, cleaning wipes, and lens cloth to clean it.
• Do not press the lens grip tool down too hard to avoid misalignment.
• Use the corresponding lens rings for the front and rear camera lenses.
• The new lens is installed correctly if the lens ring is level with the camera and not misaligned.